Frequently Asked Questions

First let's go into diagnostic mode and record all the values that are displayed as these will get erased after the next few steps. Here is a video on how to do that: Diagnostics

1. Next remove the batteries from the back of the display.
2. Clean out the tray with Isopropyl Alcohol with the display unplugged.
3. Let it dry completely, give it adequate time.
4. Turn the display back on with batteries out.
5. Do a Factory Restore (MIN, SELECT, BAROMETER) one right after another.

If the display does not come back to life at this point, proceed to the next step.

You should be on the main screen with only dashes at this point.

1. Press MAX then SELECT
(Only Min and Max should be flashing in unison, everything else will be blank.)
2. Press HUMIDITY (You'll see the word "RUN")
3. Press SELECT (You will see two letter looking icons and a number in the third digit)
4. Press MIN until the number at the end reads 0
5. Press SELECT 3 times after that and you are done.
If the unit is still not working, you will likely need a new receiver. Here is a link to that: Receiver